CAP002 is specifically designed for use with electret condenser microphones that can subsequently be used to connect to line level input sources commonly available on devises such as camcorders. PVR and other multimedia recorders, finished in black. The CAP 002 can also be used as a phantom power adaptor accepting 48V phantom power from a mixer and will convert this to 9V for Condensor microphone operation. Construction is from very strong and lightweight ABS. Input and output connections are via screw terminals.
Specifically designed for use with electret condenser microphones for connection to line level input sources
Construction is made from strong and lightweight ABS
Input and output connections are via screw terminals.
Typical frequency response 80 – 20KHz, impedance 225 Ohms balanced output, open circuit sensitivity 5mV/Pa
Finish: Black
Preamplifier Signal Type - Audio
Preamplifier Signal Type - Video
Spec Sheet available - Yes
Operating Temperature (Maximum):
140 F
Operating Temperature (Minimum):
14 F
Output Impedance:
225 ohm
Sensitivity:
-46 dB
Signal to Noise Ratio:
68 dB
DC Voltage:
24 Volts
Depth:
0.79 in
Height:
3.15 in
Width:
1.57 in
Sensitivity:
5mV/Pa (-46dBV/Pa)
Phantom Power:
48 V
Frequency Response:
80 to 20K Hz
C 007
- Boundary Layer Condenser Microphone with Omni-Directional Polar Pattern in Matt Black Finish
C 007LL
- Omni-Directional Polar Pattern Through Desk/Ceiling/Panel Mount Boundary Layer Condenser Microphone, Black
C 007N
- Boundary Layer Condenser Microphone with Omni-Directional Polar Pattern in Nickel Finish
C 007W
- Boundary Layer Condenser Microphone with Omni-Directional Polar Pattern in Matt White Finish
C007CPPW01
- 25mm Through Desk/Ceiling/Panel-mount Boundary-layer Microphone with Omni-directional Polar Pattern, Black
C007WCPPW01
- 25mm Through Desk/Ceiling/Panel-mount Boundary-layer Microphone with Omni-directional Polar Pattern, White